Stertil Koni Hydraulic 4 Post Lift Heavy Duty- 25,000kg
- Lifting Capacity: 25,000kg
- Lifting Height: 1900mm
- Platform Length: 8mtr ( also available in 6mtr/ 9mtr/ 10mtr/ 11.5mtr)
- Lifting Time: 72 seconds
- Motor: 4 x 2.2kW
- Drive-on height: 280mm
Flexible installation width The absence of any crossbeams between the platforms allows the ideal width to be set at the time of installation, ensuring easy access for personnel and for axle stands, transmission jacks etc. The platforms can be adjusted on both sides. This significantly extends the working range of the lift.
Optimum accessibility for the vehicle and the mechanic Due to the lifting height of 1900mm, the adjustable platforms and the unique design without any cross-beams, the mechanic has unrestricted access to the vehicle and an optimum working environment, allowing him to work comfortably an upright position. Equipment such as a pit jack, axle supports or a gearbox can be put in place and used easily.
Superior technology The hydraulic system is electronically controlled. This ensures a smooth lifting and lowering cycle, even in the event of an extremely uneven load distribution of the vehicle. With the absence of wear- susceptible parts ( e.g ropes and pulleys) maintenance is reduced to a minimum. Other innovative features include: programme lifting height, impact-resistance LED lights that switch on and off automatically just above floor level and a warning signal for foot protection.
Very low drive-on height The wide platforms have an extremely low drive-on height. This means that low ground clearance vehicles can also drive on easily. The standard approach ramps have a unique and ingenious design and are not an obstruction during work.
Economic electricity consumption Microprocessor controlled hydraulics and high efficiency electric motors give outstanding performance and have very low energy consumption.
User-friendly operation These heavy-duty lifts are easy to operate. The control panel is equipped with hold-to-run low voltage push buttons. The control system has a numerical on-board self-diagnostic programme providing information about the system status.
Lifetime gurantee The synthetic runner wheel system is self-lubricating and therefore does not require any maintenance. This runner wheel system comes with a lifetime guarantee.
Independent safetiesÂ
- Mechanical: the patented mechanical locking system works entirely independently of the lifting system and is permanently enabled. The mechanical locking, which is activated by gravity alone, guarantees the highest safety levels.Â
- Hydraulic: each lifting cylinder is fitted with an oil flow control valve that is enabled throughout the lifting process. An integrated overpressure valve is fitted as standard to prevent each lifting column from becoming overloaded.